G6000 Electronic Controller


The G6000 Control Card hasthe following standard features :

  • Sample Rate can be set to Time-Based or Flow-Based
  • Flow Signal type is field selectable to accept pulses, voltage (1-5 volts), or current (4-20 miliamps)
  • RTD input used to display and monitor heated sample enclosure temperature. (saperate 100 Ohm RTD sendsor required)
  • Configurable alarm output can be enabled forone or more of the following events: Low battery, Low an/or High RTD temperature and Maximum Sample Count.
  • Sample count limit can be set to disable pump or alarm after a fixed number of samples have been taken.
  • Tim-Stamped Event log for operational history.
  • Pre-saved settings can be downloaded to control card to simplify installation via SA-port.
  • Field upgradeable firmware - future updates will be availableat for free download.
  • G6000 will remember previous settings even after power is removed.

Why Aluminum Pumps vs. Stainless?

PGI's standard pump construction is hard anodized 6061-T6 aluminum. A salt spray test conducted by an independent tab concludes that "after exposure to 192 continuous hours in a 5% salt-fog environment in accordance with ASTM B 117, the 316 stainless steel bar exhibited more severe corrosive attack than the hard anodized 6061-T6 aluminum bar."

Design Features

  • Compatible with all flow computers
  • On-line serviceability
  • All materials meet NACE MR0175/ISO 15156
  • Standard pump construction is hard anodized 6061-T6 aluminum
  • CSA Approved, Intrinsically Safe, Class1, Div. 1, Group C & D Hazardous Locations
  • Direct or remote mounted
  • Inlet pressures from 10" Hg vacuum to 2200 PSIG (151.6 bar)
  • 200'F (93.3'C) Maximum Temperature